Washing Machine Tub to Pump Hose Replacement

Instructions for replacing the tub to pump hose on top loading direct drive washing machines made by Whirlpool, Kenmore, Sears, Roper, KitchenAid, Estate, Maytag, and Inglis.

Washing Machine Part: Pump Hose, Hose from tub to pump (with clamps)

Washing Machine Pump Hose

Washing Machine Pump Hose

Tools needed: flat head screwdriver, Phillips head screwdriver, pliers, putty knife.

As with any repair, be sure you’ve unplugged the appliance before beginning.

1. Your first step is to move the control panel out of the way. To do this, remove the screws found at either end. On some models these screws may be located in the rear panel, or they may be covered by plastic end-caps. Pull the end-cap off from the top to access the screw. Remove both screws and rotate the panel up. Some models use clips instead of screws to secure the control panel. Insert a putty knife between the control panel and the cabinet to release the clips.

2. Unplug the wire connector and snap out the spring clips using a flat head screwdriver.

3. Tilt the cabinet towards you, slide forward, and remove.

4. You’re now ready to remove the old hose connecting the tub to the drain pump.

5. Using pliers, release the clamps securing the hose at both ends. Be prepared for water to spill out.

6. Prepare the new hose for installation by sliding the new clamps onto the hose.

7. Now slide one end of the hose over the pump inlet port, and the other end over the tub outlet port.

8. Tighten both clamps and lock them into place with a flat head screwdriver.

9. Now reinstall the cabinet. The front edge of the cabinet slides underneath the base frame. Use your foot to push it into position. Align the notches on each side of the cabinet with the tabs on each side of the base frame. Now ease the cabinet to match up with the rear panel.

10. Reinstall the spring clips.

11. Reattach the wire connector.

12. Rotate the control panel down and lock the clips into place, or reinstall the two screws.

13. If applicable to your model, replace the end-caps by aligning the tab with the slot at the bottom and snapping the cap into position.

14. You’re now ready to plug the appliance back in to make sure it’s functioning properly.
Visit for More Washing Machine Parts

Related Posts Plugin for WordPress, Blogger...

Share and Enjoy:
  • Facebook
  • Twitter
  • StumbleUpon
  • del.icio.us
  • Digg
  • email
  • Print
Like this post? Please share to your friends:
Leave a Reply

;-) :| :x :twisted: :smile: :shock: :sad: :roll: :razz: :oops: :o :mrgreen: :lol: :idea: :grin: :evil: :cry: :cool: :arrow: :???: :?: :!: